Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router User Manual

10-18
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-10
Chapter 10 Synchronous Ethernet Support
Configuring Synchronous Ethernet
• Reproduce the current issue and collect the logs using the debug
network-clock errors, debug network-clock event, and debug
network-clock sm RP commands.
Warning We suggest you do not use these debug commands
without TAC supervision.
Note Contact Cisco Technical Support if the issue persists.
Incorrect QL values
when you use the show
network-clock
synchronization detail
command.
• Use the network clock synchronization SSM (option 1 |option 2)
command to confirm that there is no framing mismatch. Use the show
run interface command to validate the framing for a specific interface.
For the SSM option 1, framing should be SDH or E1, and for SSM option
2, it should be T1.
• Reproduce the issue using the debug network-clock errors and debug
network-clock event RP commands or enable the debug hw-module
subslot command. (This is specific to SIP-400).
Warning We suggest you do not use these debug commands
without TAC supervision.
Table 10-3 Troubleshooting Scenarios (continued)
Problem Solution

Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Specifications

General

Brand	Cisco
Model	ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
Category	Network Router
Language	English