28
MCP_SCAL_R1#sho plat
Chassis type: ASR1002
The following output displays:
MCP_SCAL_R1#
If the LEDs indicate a power problem or the power supply state is ps,fail, then contact a customer service representatives for
assistance or additional instructions.
Start the Cisco ASR 1002 Router
After installing your Cisco ASR 1002 Router and connecting cables, start the router as follows.
Check the following conditions before you start the Cisco ASR 1002 Router:
• The Cisco ASR 1002 Router has one slot for FP0 with three subslots for SPAs, subslots 1, 2, and 3. Make certain that each
shared port adapter is firmly seated in its subslot and its captive screws are securely tightened.
• The Cisco ASR1000-ESP5 or ASR1000-ESP10 forwarding processor in the Cisco ASR 1002 router is inserted in slot F0, is
firmly seated in its slot, and its captive screws are securely tightened.
• All network interface cables are connected.
• The console terminal is turned on.
Step 1 Turn on power. The green OK LED on the power supply turns on. (Both power supplies are required in the Cisco
ASR 1002 Router.)
Step 2 Listen for the fans; you should immediately hear them operating.
Step 3 During the boot process, observe the system LEDs. The power LED should be green. The STATUS LED lights yellow
to indicate booting and then green when Cisco IOS is running.
Table 3 provides information about the LEDs as the system starts.
Table 3 Cisco ASR 1002 Router LED Activity
Slot Type State Insert Time
1 ASR1000-SIP10 ok 00:03:19
1/1 SPA-8X1GE-V2 ok 00:02:23
2 ASR1000-SIP10 ok 00:03:19
2/0 SPA-1X10GE-L-V2 ok 00:02:22
2/1 SPA-8X1GE-V2 ok 00:02:17
R0 ASR1000-RP1 ok,active 00:03:19
F0 ASR1000-ESP10 ok,active 00:03:19
P0 ASR1002-PWR-AC ok 00:02:50
P1 ASR1002-PWR-AC ps, fail 00:02:50
Slot CPLD Version Firmware
Version
1 07091401 12.2(33r)XN2
2 07091401 12.2(33r)XN2
R0 08060301 12.2(0:0)
F0 08041102 12.2(33r)XN2
LED Label LED Color In the Power Up State -Behavior Description
PWR Power Solid green All power requirements are within specification.
Off The router is in standby mode.
To Next Page
Loading...
