D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013. www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
15
Cisco TelePresence System Quick Set C20 and Profiles using C20 Administrator Guide
Navigate to: Call Control > Call Control
Placing a call
You can use the Call Control page of the web interface to
initiate a call.
Even if the web interface is used to initiate the call
it is the video system (display, microphones and
loudspeakers) that is used for the call; it is not the PC
running the web interface.
Calling
You can call someone either by choosing a contact name in
the Local phone book or Directory, or by typing a complete
URI or number in the Search and Dial field. Then click Call in
the associated contact card.
Searching the contact lists
Enter one or more characters in the Search or Dial field.
Matching entries from both the Local phone book and the
Directory will be listed as you type.
Select the entry in the phone book or directory before you
click Call.
Calling more than one
A point-to-point video call (a call involving two parties only)
may be expanded to include one more participant. This
participant can join on audio-only.
Follow the same procedure to call the next conference
participant as you did when calling the first participant.
Calling someone
Click a contact name, either in the
Local phone book or in the Directory.
Then click Call in the contact card.
Alternatively, enter the complete URI
or number in the Search and Dial field.
Then click the Call button that appears
next to the URI or number.
Ending a call
To disconnect just one
participant in a call, click
the
button for that
participant.
Click the End all button to
terminate the entire call.
Holding and resuming
Use the
button next
to the participant’s name
to put him on hold.
To resume the call,
use the button
that appears for the
participant on hold.
To Next Page
Loading...
Need help?
General
