Cisco C20 TelePresence System User Manual

D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013. www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
54
Cisco TelePresence System Quick Set C20 and Profiles using C20 Administrator Guide
Cameras Camera [1..1] DHCP
Applies to cameras which support DHCP (for example the Cisco TelePresence PrecisionHD
1080p 12X camera). The camera must be connected to a LAN. When set, the command
enables support for SW upgrade of daisy chained cameras. It will enable the camera's DHCP
function and force start of MAC and IP address retrieval. Remember to reset the DHCP when
the camera is no longer connected to a LAN.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is
not connected to a LAN.
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the
DHCP is started and the IP address will be retrieved. Run the commnand "xStatus Camera"
for result.
Example:
Cameras Camera 1 DHCP: Off
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
System settings

Cisco C20 TelePresence System Specifications

General

Brand	Cisco
Model	C20 TelePresence System
Category	Conference System
Language	English