Cisco Catalyst 3550

Chapter 2 Installing and Starting the Switch
Connecting to the GBIC Module Ports
2-38
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-03
Step 6 Repeat Steps 1 through 5 to connect each port.
Connecting to the GBIC Module Ports
These sections describe how to connect to a GBIC module port. For detailed
instructions on installing, removing, and cabling a GBIC (1000BASE-X module,
1000BASE-T module, or the GigaStack module), refer to your GBIC
documentation.
Connecting to a 1000BASE-X GBIC Module Port
Caution Do not remove the rubber plugs from the fiber-optic port or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the fiber-optic port and cable from contamination and ambient light.
Avoid exposure to the laser beam.
Follow these steps to connect to the 1000BASE-X GBIC port:
Step 1 Remove the rubber plugs from the fiber-optic port on the module, and store them
for future use.
Step 2 Insert the SC connector in the fiber-optic receptacle, as shown in Figure 2-36.