2-15
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
CLS_ACC Messages
Error Message CLS_ACC-3-UNABLE_TO_RESET_CONFIG: [chars]
Explanation The switch cannot reset the configuration.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message CLS_ACC-3-VLAN_CREATE_FAIL: Failed to allocate a free vlan as
consoleless access vlan,use default mamagement vlan
Explanation The switch cannot find a VLAN with an ID from 2 to1000 to be the management VLAN
for consoleless access.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message CLS_ACC-4-NO_HTTP_PAGE: Failed to locate HTTP page for the consoleless
access mode
Explanation The switch cannot find the HTTP page that appears in Express Setup mode because the
page is not on the flash memory.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message CLS_ACC-4-UNEXPECTEDEVENT: Switch does not support or not ready for
consoleless access mode
Explanation The switch does not support or is not ready to go into the consoleless access mode.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.