Contents
iii
Cisco Catalyst 3850 Series and Cisco Catalyst 3650 Series Switches Best Practices Guide
Recommendations for Configuring the Uplink Interface to a Router or Switch 5-44
Configure QoS on the Uplink EtherChannel Interfaces 5-44
Configure the Uplink Interface as an EtherChannel and as a Trunk 5-45
Configure the Uplink Interface to Connect to Distribution VSS or VPC Switches 5-45
Configure the Uplink Interface to Connect to Distribution Routers (or Standalone Distribution
Switches)
5-46
Configure Security Features on the Uplink EtherChannel Interfaces 5-48
Spanning-Tree Recommendations for Uplink Interfaces Connecting to Distribution Switches 5-48
Verify Uplink Interface Configurations 5-49
Show Running Configuration for Uplink Interface Connectivity 5-49
Access Interface Connectivity 6-51
Purpose 6-51
Prerequisites 6-51
Identify Configuration Values 6-51
LAN Access Switch Topology with Connections to End Devices 6-53
Configure Access Interface Connectivity 6-53
Recommendations for Configuring Access Interfaces 6-53
Configure the Interface for Access Mode 6-55
Configure VLAN Membership 6-55
Create an Interface Description 6-55
Configure Security Features on Access Interfaces 6-56
Configure QoS on the Access Interfaces 6-57
Verify Access Interface Configurations 6-58
Show Running Configuration for Access Interface Connectivity 6-61
Access Control on the Wired Network 7-65
Purpose 7-65
Prerequisites 7-65
Restrictions 7-65
Identify Configuration Values 7-66
LAN Access Switch Topology with IEEE 802.1x Secure Access Control 7-67
Provision IEEE 802.1x for Wired LAN 7-67
Recommendations for Configuring Security on a Wired LAN 7-67
Provision Common Wired Security Access 7-68
Provision in Monitor Mode 7-71
Provision in Low Impact Mode 7-72
Provision in High Impact Mode 7-73
Verify Secure Access Control on the Switch 7-74
To Next Page
Loading...
Need help?
General
