Contents
iv
Cisco Catalyst 3850 Series and Cisco Catalyst 3650 Series Switches Best Practices Guide
Show Running Configuration for Provisioning Modes 7-74
Monitoring IEEE 802.1x Status and Statistics 7-77
Converged Wired and Wireless Access 8-81
Purpose 8-81
Prerequisites 8-81
Restrictions 8-82
Identify Configuration Values 8-82
LAN Access Switch Topology with Wireless Connectivity 8-83
Enable the Switch as a Wireless Controller 8-84
Install Access Point Licenses on the Switch 8-84
Verify AP-Count License Installation 8-85
Configure a Wireless Management VLAN 8-86
Configure Service Connectivity 8-86
Enable Wireless Controller Functionality 8-87
Change a Switch to Run in Mobility Controller Mode 8-87
Enable the Access Point Connections 8-88
Enable a Client VLAN 8-89
Provisioning a Small Branch WLAN 8-90
Provision in Easy-RADIUS 8-90
Disable Authentication to Enable Easy-RADIUS 8-90
Configure QoS to Secure the WLAN 8-91
Verify Client Connectivity in RADIUS 8-91
Provision in Secure Mode 8-93
Enable the AAA RADIUS Server 8-93
Configure the WLAN with IEEE 802.1x Authentication 8-94
Configure QoS Service Policies for an Open WLAN 8-94
Obtain WLAN Client IP Addresses 8-95
Manage Radio Frequency and Channel Settings 8-95
Disable Low Data Rates 8-96
Enable Clean Air 8-97
Enable Dynamic Channel Assignment 8-97
Associate WLAN Clients 8-98
Verify WLAN Client Connectivity 8-98
Verify the Converged Access Configuration on the Switch 8-99
Show Running Configuration for Wireless LAN Converged Access 8-99
System Health Monitoring 9-103
Purpose 9-103
To Next Page
Loading...
Need help?
General
