Cisco Catalyst C9300-24T User Manual

• While installing C9300 network modules, position the module face up to install it in the module slot.
Slide the module into the slot until the screw makes contact with the chassis. Fasten the captive screws
to secure the network module in place.
Figure 41: Installing the C9300 Network Module in the Switch
• While installing C9300X network modules, position the module face up to install it in the module slot.
Slide the module into the slot until the back of the module faceplate is flush with the switch faceplate.
Secure the network module in place by the ejector and the latch.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
71
Installing a Network Module
Installing a Network Module

Cisco Catalyst C9300-24T Specifications

General

Model	C9300-24T
Product Type	Switch
Form Factor	Rack-mountable
Ports	24 x 10/100/1000 Ethernet Ports
DRAM	8 GB
Flash	16 GB
Stacking Bandwidth	480 Gbps
PoE Support	No
Stacking	Yes
Input Voltage	100V to 240V AC
Operating Temperature	0 to 45°C
Operating Humidity	5% to 95% non-condensing