Removing SFP, SFP+ and SFP28 Modules
Procedure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.
Step 2 Disconnect the cable from the SFP/SFP+/SFP28 module. For reattachment, note which cable connector plug
is send (TX) and which is receive (RX).
Step 3 Insert a dust plug into the optical ports of the SFP/SFP+/SFP28 module to keep the optical interfaces clean.
Step 4 If the module has a bale-clasp latch, pull the bale out and down to eject the module. If you cannot use your
finger to open the latch, use a small, flat-blade screwdriver or other long, narrow instrument to open it.
Step 5 Grasp the SFP/SFP+/SFP28 module, and carefully remove it from the slot.
Step 6 Place the SFP/SFP+/SFP28 module in an antistatic bag or other protective environment.
Finding the Network Module Serial Number
If you contact Cisco Technical Assistance regarding a network module, you need to know its serial number.
Figure 27: Network Module Serial Number Location
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
53
Installing a Network Module
Removing SFP, SFP+ and SFP28 Modules
To Next Page
Loading...