Name: Cisco Catalyst C9300-48UXM
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Figure 39: Removing the Blank Module

Verify the correct orientation of your module before installing it. Incorrect installation can damage

the module.

Caution

Do not install the network module with connected cables or installed pluggable transceivers.

Always remove any cables and transceiver modules before you install the network module.

Caution

A module interface might become error-disabled when a network module with connected

fiber-optic cables is installed or removed. If an interface is error-disabled, you can reenable the

interface by using the shutdown and no shutdown interface configuration commands.

Caution

Step 4 Position the module face up to install it in the module slot. Slide the module into the slot until the screw makes

contact with the chassis. Fasten the captive screws to secure the network module in place.

Figure 40: Installing the Network Module in the Switch

Step 5 Do one of the following:

Cisco Catalyst 9300 Series Switches Hardware Installation Guide

Installing a Network Module

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst C9300-48UXM and is the answer not in the manual?

Cisco Catalyst C9300-48UXM Specifications

General