Do not disconnect connections to this equipment unless power has been removed or you have verified
that the area is nonhazardous. Secure any external connections that mate to this equipment by using screws,
sliding latches, threaded connectors, or other means provided with this product.Statement 1062
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
Voltages that present a shock hazard may exist on Power over Ethernet (PoE) circuits if interconnections
are made using uninsulated exposed metal contacts, conductors, or terminals. Avoid using such
interconnection methods, unless the exposed metal parts are located within a restricted access location
and users and service people who are authorized within the restricted access location are made aware of
the hazard. A restricted access area can be accessed only through the use of a special tool, lock and key
or other means of security. Statement 1072
Warning
No user-serviceable parts inside. Do not open. Statement 1073Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074Warning
Hot surface. Statement 1079Warning
Explosion Hazard—The area must be known to be nonhazardous before installing, servicing, or replacing
the unit.Statement 1082
Warning
Box Contents
You will receive a Cisco Catalyst Digital Building UPOE (CDB-8U) or a PoE+ (CDB-8P) Switch. Each
switch is shipped in a separate box.
To install the switch, you will require one of the mounting accessories listed below. You can order them when
you order your switch, or you can order them later from your Cisco representative.
•
Flexible mount with IEC C14 power junction box (CDB-MNT-FLEX-C14)
• Flexible mount with direct-wired junction box (CDB-MNT-FLEX-DIR) — Plenum-rated
•
5RU 19" rack mount chassis for up to 5 switches (CDB-MNT-RACK5-C14)
Catalyst Digital Building Series Switch Hardware Installation Guide
15
Switch Installation
Box Contents
To Next Page
Loading...
Need help?
General