Step 9
Secure all excess wire in the raceway. Ensure that no exposed conductors are present.
Step 10
Secure junction box cover with screws.
Step 11
Once all wiring is complete, re-energize the supply circuit.
Step 12
Install switches into the mounts and check for proper operation.
Flexible Mount with IEC C14 Power Junction Box
To connect to a power source, follow these steps:
Procedure
Step 1
Plug the IEC C14 power cord into the power connector on the flexible mount.
Step 2
Plug the other end of the power cord into a power source.
Catalyst Digital Building Series Switch Hardware Installation Guide
65
Switch Installation
Flexible Mounting
To Next Page
Loading...
Need help?
General