Index
IN-4
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-17439-01
SFP-OC3-IR1 1-5, 3-11, 3-15
SFP-OC3-LR1 1-5, 3-11, 3-15
SFP-OC3-LR2 1-5, 3-11, 3-15
SFP-OC3-MM 1-5, 3-11, 3-15
SFP-OC3-SR 1-5, 3-11, 3-15
SFP-OC48-IR1 1-5, 3-21
SFP-OC48-LR2 1-5, 3-21
SFP-OC48-SR 1-5, 3-21
SFP optical transceiver modules
(figure)
3-12
cleaning 6-7
for OC-12c/STM-4 Multirate POS SPA 3-14, 3-16
for OC-3c/STM-1 POS SPA 3-10, 3-11
for OC-48c/STM-16 POS/RPR SPA 3-21
shared port adapter
see SPA
short-reach
SFP optical transceiver module
3-11, 3-15
XFP optical transceiver module 3-21, 3-24
show commands to display SPA information 6-8
simplex MTP connector
(figure)
3-28
SIP 2-1, 4-1
blank filler plate 1-1
definition 1-1
general characteristics 1-1
hardware revision 2-1
installation troubleshooting 7-1
LEDs 2-2, 7-1
oversubscription 7-2
packing 7-4
physical specifications 2-2
product number 2-1
slot numbering 2-4
slots 2-3
software version 2-1
status 6-8
subslots 1-1
tools and parts required for installation 4-1
verifying the installation 6-7
slot locations on router 2-3
slot numbering on SIP 2-4
slot number on router 2-6
small form-factor pluggable
see XFP or SFP
SPA
3-1, 4-1
10-Port Gigabit Ethernet 3-36
1-Port 10-Gigabit Ethernet 3-39
1-Port OC-192c/STM-64 POS/RPR VSR Optics 3-26
1-Port OC-192c/STM-64 POS/RPR XFP 3-22
2-Port and 4-Port Clear Channel T3/E3 3-43
2-Port and 4-Port OC-48c/STM-16 POS 3-19
4-Port OC-3c/STM-1 POS 3-7
5-Port Gigabit Ethernet 3-28
8-Port Gigabit Ethernet 3-32
8-Port OC-12c/STM-4 Multirate POS 3-14
cable- management brackets 6-9
definition 1-2
failed 7-2
information using show commands 6-8
interfaces 1-2
number of supported 2-1
packing 7-4
sizes 1-2
status 6-8
tools and parts required for installation 4-1
verifying the installation 6-7
SPA interface processor
see SIP
status of SPA
6-8
subslot numbers on SIP 2-7
subslots on a SIP 1-1
T
troubleshooting SIP installation 7-1
To Next Page
Loading...
