3-15
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-17439-01
Chapter 3 Overview: Cisco CRS-1 Shared Port Adapters
8-Port OC-12c/STM-4 Multirate POS SPA Overview
8-Port OC-12c/STM-4 Multirate POS SPA Interface Specifications
The framer processes incoming and outgoing SONET or SDH frames. The framer operates at OC-3 line
rates (155.52 Mbps) and OC-12 line rates (622.08 Mbps). Packet data is transported with a
user-configured encapsulation (such as Point-to-Point Protocol [PPP]) and is mapped into the Layer 2
fr
ame.
The 8-Port OC-12c/STM-4 Multirate POS SPA i
nterface complies with the following RFCs:
• RFC 1662, PPP in HDLC-like Framing
• RFC 2427, Multiprotocol Interconnect over Frame Relay
• RFC 2615, PPP over SONET/SDH
8-Port OC-12c/STM-4 Multirate POS SPA Optical Transceiver Modules and
Cables
The 8-Port OC-12c/STM-4 Multirate POS SPA uses a small form-factor pluggable (SFP) optical
transceiver module installed in each port for SONET and SDH single-mode and multimode optical fiber
connections (see Figure 3-12).
Cisco Systems qualifies the optics that are approved fo
r use with its SPAs. The following OC-3 optical
transceiver modules are supported on the 8-Port OC-12c/STM-4 Multirate POS SPA:
• Multimode (MM) SFP module—SFP-OC3-MM
• Short-reach (SR) SFP module—SFP-OC3-SR
• Intermediate-reach (IR) SFP module (15 km)—SFP-OC3-IR1
• Long-reach (LR) SFP module (40 km)—SFP-OC3-LR1
• Long-reach (LR) SFP module (80 km)—SFP-OC3-LR2
The following OC-12 optical transcei
ver modules are supported on the 8-Port OC-12c/STM-4 Multirate
POS SPA:
• Multimode (MM) SFP module—SFP-OC12-MM
• Short-reach (SR) SFP module—SFP-OC12-SR
• Intermediate-reach (IR) SFP module (15 km)—SFP-OC12-IR1
• Long-reach (LR) SFP module (40 km)—SFP-OC12-LR1
• Long-reach (LR) SFP module (80 km)—SFP-OC12-LR2
A/L Off Off Interface is shut down.
Green On Port is enabled by software, and loopback is off.
Amber On Port is enabled by software, and loopback is on.
STATUS Off Off SPA power is off.
Green On SPA is ready and operational.
Amber On SPA power is on and good, and the SPA is being configured.
Table 3-7 8-Port OC-12c/STM-4 Multirate POS SPA LEDs (continued)
LED Label Color State Meaning