Cisco CRS-1 - Carrier Routing System Router

To Next Page

To Previous Page

2-7

Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide

OL-17439-01

Chapter 2 Overview: Cisco CRS-1 SPA Interface Processor

Identifying Slots and Subslots for SIPs and SPAs

• subslot—Specifies the secondary slot on the SIP in which the SPA that you want to select is

installed: for the Cisco CRS-1 SIP-800—0 through 5

• port—Specifies the interface number that you want to select on the SPA:

–

For the 1-Port Clear Channel OC-3 ATM SPA—0 is the only option

–

For the 3-Port Clear Channel OC-3 ATM SPA—0 through 2

–

For the 1-Port Clear Channel OC-12 ATM SPA —0 is the only option

–

For the 4-Port OC-3c/STM-1 POS SPA—0 through 3

–

For the 8-Port OC-12c/STM-4 Multirate POS SPA—0 through 7

–

For the 2-Port OC-48c/STM-16 POS/RPR SPA—0 through 1

–

For the 4-Port OC-48c/STM-16 POS/RPR SPA—0 through 3

–

For the 1-Port OC-192c/STM-64 POS/RPR XFP SPA—0 is the only option

–

For the 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA—0 is the only option

–

For the 5-Port Gigabit Ethernet SPA—0 through 4

–

For the 8-Port Gigabit Ethernet SPA—0 through 7

–

For the 10-Port Gigabit Ethernet SPA—0 through 9

–

For the 1-Port 10-Gigabit Ethernet SPA—0 is the only option

–

For the 2-Port Clear Channel T3/E3 SPA—0 through 1

–

For the 4-Port Clear Channel T3/E3 SPA—0 through 3

Other manuals for Cisco CRS-1 - Carrier Routing System Router