EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-9
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-17439-01
Chapter 3 Overview: Cisco CRS-1 Shared Port Adapters
1-Port Clear Channel OC-12 ATM SPA Overview
Figure 3-6 SFP Optics Module
The 1-Port Clear Channel OC-12 ATM SPA provides the following optical fiber options:
Multimode—622.08-Mbps, OC-12 optical fiber (SONET STS-12c or SDH STM-4)
Use a multimode optical fiber that has a core/cladding diameter of 62.5/125 microns.
Single-mode—622.08-Mbps, OC-12 optical fiber (SONET STS-12c or SDH STM-4)
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal
d
iameter is approximately 10/125 microns.)
For single-mode and multimode optical fiber connections, you c
an use either a duplex LC-type cable (see
Figure 3-7) o
r two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
Figure 3-7 Duplex Patch Cable with LC-Type Connectors
127158
/ / / /
/ /
TXRX
84929

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals