Command History
ModificationRelease
This command was introduced.Release 2.0
The combined, hw, and sw keywords were added.Release 3.3.0
The combined, hw, and sw keywords were deleted.Release 3.4.0
The combined, hw, and sw keywords were added.Release 3.4.1
The pre-decrypt, post-decrypt, post-encrypt, and pre-decrypt
keywords were removed.
Release 3.5.0
The combined, hw, and sw keywords were removed.
The member type interface-path-id keyword and arguments were added.
Release 3.6.0
The command output displays ECN-based WRED details.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The show policy-map interface command displays the statistics for classes in the service policy attached to
an interface.
Task ID
OperationsTask ID
readqos
Examples
The following sample output shows how to display policy statistics information for all classes on the TenGigE
interface 0/6/1/0 that are in the output and input direction:
RP/0/RP0/CPU0:router# show policy-map interface tengige 0/6/1/0
TenGigE0/6/1/0 input: policy1
Class class1
Classification statistics (packets/bytes) (rate - kbps)
Matched : 0/0 0
Transmitted : 0/0 0
Total Dropped : 0/0 0
Policing statistics (packets/bytes) (rate - kbps)
Policed(conform) : 0/0 0
Policed(exceed) : 0/0 0
Policed(violate) : 0/0 0
Policed and dropped : 0/0
Queueing statistics
Queue ID : 44
Taildropped(packets/bytes) : 0/0
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 127
Quality of Service Commands on the Cisco IOS XR Software
show policy-map interface
To Next Page
Loading...
Need help?
General
