Cisco Expressway CE1200 Installation Guide

5. In the Serial over LAN Properties, check Enabled and then click Save Changes. This step is necessary as
serial over LAN is disabled by default.
Task 3: Connect to the Expressway console (any time you need to)
1. In a terminal emulator, use SSH to connect to the CIMC IP address.
2. Type the default username admin and your CIMC password, and press Enter.
3. Type connect host and press Enter.
4. You are now connected to the Expressway console using serial over LAN.
Wait for the Install Wizard to appear, and then go on to the next section Run the Install Wizard, page 17.
16
Cisco Expressway CE1200 Appliance Installation Guide
Connect to the Expressway Console

Cisco Expressway CE1200 Specifications

General

Brand	Cisco
Model	Expressway CE1200
Category	Server
Language	English