Need help?Do you have a question about the Cisco Expressway CE1200 and is the answer not in the manual?
General| CPU Cores | 8 |
|---|---|
| Power Supply | Dual redundant power supplies |
| Operating System | Cisco Expressway |
| CPU | Intel Xeon |
| Memory | 32 GB |
| Network Interfaces | 4 x 1G Ethernet |
| Model | Cisco Expressway CE1200 |
| Form Factor | 1U Rackmount |
| Storage | 2 x 480 GB SSD |
Details the physical components and UCS equivalent part numbers for the CE1200 Appliance.
Details the front panel layout, including the arrangement of LEDs and ports on the Cisco Expressway.
Details the rear panel layout, including the arrangement of ports and LEDs on the Cisco Expressway.
Essential safety procedures and general information for installing communications equipment.
Details on installing the appliance into a rack, referencing the Cisco UCS C220 M5 Server Installation Guide.
Steps for connecting power cords and powering on the appliance for the first time and initial boot.
Describes methods for connecting to the Expressway console for initial configuration via serial or CIMC.
Guide to configuring CIMC IP address and setting a strong password for secure management access.
Guidance on launching and navigating the Cisco Expressway Install Wizard after initial boot.
Guide on using the SD card for configuration reinstallation via CIMC and KVM console.
Procedures for performing an IRP reinstall using the KVM console after preparing the virtual drive.
To Next Page
