Cisco Expressway CE1200

CHAPTER 9
Run the Install Wizard
• Run the Install Wizard, on page 27
Run the Install Wizard
After the system boots up the terminal emulator program on the PC displays Cisco Expressway startup
information. After approximately four minutes the Install Wizard is displayed.
If the Cisco Expressway was already on when you connected and you don't see the Install Wizard, press
Ctrl+D to access it. If you encounter issues or enter incorrect information during the wizard you can press
Ctrl+D to restart it.
Install Wizard Process
Cisco Expressway CE1200 Appliance Installation Guide (14.0)
27