Cisco Firepower 1010 Hardware Installation Guide

—Network
Status of the network ports.
Connection-speed status (S):
• Green, flashing—One flash every three
seconds = 10 Mbps.
• Green, flashing—Two rapid flashes = 100
Mbps.
• Green, flashing—Three rapid flashes = 1000
Mbps.
5
Hardware Specifications
The following table contains hardware specifications for the Firepower 1010.
Table 2: Firepower 1010 Hardware Specifications
1.82 x 7.85 x 8.07 inches (4.62 x 19.94 x 20.50 cm)Dimensions (H x W x D)
3 lb (1.36 kg)Weight
30 W
Not including any PoE devices connected to the chassis. 55 W is the maximum
power for the power supply.
PoE+ is first supported in FTD Version 6.5.
Note
Use the power supply (part number 341-100765-01) that shipped with
the chassis. It supports PoE+.
Note
System power
Operating: 32 to 104°F (0 to 40°C)
Derate the maximum operating temperature 1.5° C per 1000 ft above sea level.
Nonoperating: -13 to 158°F (-25 to 70°C) maximum altitude is 40,000 ft
Because the Firepower 1010 has no fan, the internal system temperature
is significantly higher than the operating temperature.
Note
Temperature
Operating: 90%
Nonoperating: 10 to 90%
Humidity
Operating: 0 to 9843 (3000 m)
Nonoperating: 0 to 15,000 ft (4570 m)
Altitude
0 dBaAcoustic noise
Cisco Firepower 1010 Hardware Installation Guide
11
Overview
Hardware Specifications

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB