Cisco Firepower 1010 Hardware Installation Guide

commands that are available to disk0 are also available to disk1, including copy, format, delete,
mkdir, pwd, cd, and so on.
• FAT-32 File System—The Firepower 1010 only supports FAT-32-formatted file systems for the
external USB drive. If you insert an external USB drive that is not in FAT-32 format, the system
mounting process fails, and you receive an error message. You can enter the command format
disk1: to format the partition to FAT-32 and mount the partition to disk1 again; however, data might
be lost.
Package Contents
The following figure shows the package contents for the Firepower 1010. Note that the contents are subject
to change and your exact contents might contain additional or fewer items.
Figure 2: Firepower 1010 Package Contents
USB console cable (Type A to Mini Type B)
Part number 37-19770-01
2Chassis1
Power supply4Power cord
See Power Cord Specifications, on page 12 for
a list of the approved power cords.
3
—Cisco Firepower 1010
This document has a URL pointing to the
hardware installation guide, a URL pointing to
the regulatory and safety guide, and a QR code
and URL pointing to the Getting Started Guide.
5
Cisco Firepower 1010 Hardware Installation Guide
5
Overview
Package Contents

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB