Cisco Firepower 1010 Hardware Installation Guide

CHAPTER 1
Overview
• Features, on page 1
• Package Contents, on page 5
• QR Code Sticker, on page 6
• Serial Number Location, on page 7
• Front Panel, on page 7
• Rear Panel, on page 7
• Status LEDs, on page 8
• Hardware Specifications, on page 11
• Product ID Numbers, on page 12
• Power Cord Specifications, on page 12
Features
The Cisco Firepower 1010 security appliance is an NGFW desktop product in the Cisco Firepower family of
devices with Power over Ethernet (PoE+) and L2 switch support.
The PoE+ and L2 switch features are supported starting with Firepower Threat Defense (FTD) Version 6.5
and ASA Version 9.13.
Note
See the Cisco Firepower Compatibility Guide, which provides Cisco Firepower software and hardware
compatibility, including operating system and hosting environment requirements, for each supported Firepower
version.
See Product ID Numbers, on page 12 for a list of the product IDs (PIDs) associated with the Firepower 1010.
The following figure shows the Cisco Firepower 1010.
Cisco Firepower 1010 Hardware Installation Guide
1

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB