Cisco Firepower 1010 - Page 6

Figure 1: Cisco Firepower 1010
The following table lists the features for the Firepower 1010.
Table 1: Firepower 1010 Features
DescriptionFeature
• Certified on FTD 6.4.x and FX-OS 2.6.x:
• Common Criteria Certification for the Network Device Collaborative Protection
Profile, (NDcPPv2.2E)
• IPS Extended Package (IPSEP v2.11)
• Firewall Collaborative Protection Profile Module (MOD_FW_v1.4e)
• Virtual Private Network Gateway Protection Profile Module
(MOD_VPNGW_v1.1)
• Federal Information Processing Standards (FIPS) 140-2 on FTD 6.4.x and FX-OS
2.6.x
• Department of Defense Information Network Approved Product List (DoDIN APL)
• US Government Compliance for IPv6 (USGv6) on FTD 7.0.x— Certification Approval
under the R1 Profile for the Product Classification “NPP.”
See the "Security Certifications Compliance" topic in the "Appliance Platform Settings"
chapter in the Firepower Management Center Configuration Guide, Version 6.7 for the
instructions on how to enable security certifications compliance.
Security
standards
certifications
1 RUForm factor
Desktop mount
Wall mount (Cisco part number 69-100647-01)
Rack mount (Cisco part number 800-107605-01)
Mounting
Side-to-side
No fan
Because the Firepower 1010 has no fan, the internal system temperature is
significantly higher than the ambient temperature cited in Hardware
Specifications, on page 11.
Note
Airflow
Cisco Firepower 1010 Hardware Installation Guide
2
Overview
Features