Cisco Firepower 1010 Hardware Installation Guide

CHAPTER 5
Installation, Maintenance, and Upgrade
• Install the FIPS Opacity Shield , on page 41
Install the FIPS Opacity Shield
Because the FIPS opacity shield covers the serial number on the chassis, the CO should copy the serial number
and store it in a secure place. The serial number is needed when you call Cisco TAC. See Serial Number
Location, on page 7 for the location of the serial number.
Note
You can only install the FIPS opacity shield with the desktop mount or wall mount. The rack mount does not
support the FIPS shield. See Desktop-Mount the Chassis, on page 28 and Wall-Mount the Chassis, on page
28 for more information.
Note
Before you begin
This procedure should be performed only by the Crypto Officer (CO).
Caution
You need the following to install the FIPS opacity shield:
• #1 Phillips head screwdriver
• The following items from the FIPS kit (part number 69-100649-01):
• One FIPS opacity shield (part number 800-106088-01)
• Three M3 x 66 mm (part number 48-0384-01) screws used to attach the FIPS opacity shield to the
chassis
• Nine Tamper Evidence Labels (TELs) (part number 47-25553-01)
Cisco Firepower 1010 Hardware Installation Guide
41

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB