Cisco Firepower 1100 Getting Started Guide

Cable the Firewall
This topic describes how to connect the Firepower 1100 to your network so that it can be managed by CDO.
Figure 42: Cabling the Firepower 1100
You can connect to CDO on any data interface or the Management interface, depending on which interface
you set for manager access during initial setup. This guide shows the outside interface.
Procedure
Step 1 Install the chassis. See the hardware installation guide.
Step 2 Connect the outside interface (for example, Ethernet 1/1) to your outside router.
You can use any data interface or the Management interface for manager access. However, this guide primarily
covers outside interface access, because it is the most likely scenario for remote branch offices.
Step 3 Connect the inside interface (for example, Ethernet 1/2) to your inside switch or router.
You can choose any interface for inside.
Step 4 Connect other networks to the remaining interfaces.
Step 5 Connect the management computer to the console port or the Ethernet 1/2 interface.
If you perform intial setup using the CLI, you will need to connect to the console port. The console port may
also be required for troubleshooting purposes. If you perform initial setup using the device manager, connect
to the Ethernet 1/2 interface.
Cisco Firepower 1100 Getting Started Guide
125
Threat Defense Deployment with CDO
Cable the Firewall

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English