Cisco Firepower 1100 Getting Started Guide

Power on the Device, on page 164.Pre-Configuration
(Optional) Change the IP Address, on page 165.ASA CLI
Log Into the ASDM, on page 166.ASDM
Configure Licensing, on page 167: Obtain feature licenses.Cisco Commerce
Workspace
Configure Licensing, on page 167: Generate a license token for the chassis.Smart Software Manager
Configure Licensing, on page 167: Configure feature licenses.ASDM
Configure the ASA, on page 172.ASDM
Review the Network Deployment and Default Configuration
The following figure shows the default network deployment for the Firepower 1100 using the default
configuration.
If you connect the outside interface directly to a cable modem or DSL modem, we recommend that you put
the modem into bridge mode so the ASA performs all routing and NAT for your inside networks. If you need
to configure PPPoE for the outside interface to connect to your ISP, you can do so as part of the ASDM Startup
Wizard.
If you cannot use the default inside IP address for ASDM access, you can set the inside IP address at the ASA
CLI. See (Optional) Change the IP Address, on page 165. For example, you may need to change the inside IP
address in the following circumstances:
• If the outside interface tries to obtain an IP address on the 192.168.1.0 network, which is a common
default network, the DHCP lease will fail, and the outside interface will not obtain an IP address. This
problem occurs because the ASA cannot have two interfaces on the same network. In this case you must
change the inside IP address to be on a new network.
• If you add the ASA to an existing inside network, you will need to change the inside IP address to be on
the existing network.
Note
Cisco Firepower 1100 Getting Started Guide
161
ASA Deployment with ASDM
Review the Network Deployment and Default Configuration

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English