Cisco Firepower 1100 Getting Started Guide

Firepower 1100 Default Configuration
The default factory configuration for the Firepower 1100 configures the following:
• inside→outside traffic flow—Ethernet 1/1 (outside), Ethernet 1/2 (inside)
• outside IP address from DHCP, inside IP address—192.168.1.1
• management—Management 1/1 (management), IP address from DHCP
• DHCP server on inside interface
• Default routes from outside DHCP, management DHCP
• ASDM access—Management and inside hosts allowed. Inside hosts are limited to the 192.168.1.0/24
network.
• NAT—Interface PAT for all traffic from inside to outside.
• DNS servers—OpenDNS servers are pre-configured.
The configuration consists of the following commands:
interface Management1/1
management-only
nameif management
security-level 100
ip address dhcp setroute
no shutdown
!
interface Ethernet1/1
Cisco Firepower 1100 Getting Started Guide
162
ASA Deployment with ASDM
Firepower 1100 Default Configuration

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English