Cisco Firepower 1100 Getting Started Guide

firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 2 Connect to the threat defense CLI.
connect ftd
Example:
firepower# connect ftd
>
Step 3 The first time you log into the threat defense, you are prompted to accept the End User License Agreement
(EULA). You are then presented with the CLI setup script.
Defaults or previously-entered values appear in brackets. To accept previously entered values, press Enter.
See the following guidelines:
• Enter the IPv4 default gateway for the management interface—If you set a manual IP address, enter
either data-interfaces or the IP address of the gateway router. The data-interfaces setting sends outbound
management traffic over the backplane to exit a data interface. This setting is useful if you do not have
a separate Management network that can access the internet. Traffic originating on the Management
interface includes license registration and database updates that require internet access. If you use
data-interfaces, you can still use the device manager (or SSH) on the Management interface if you are
directly-connected to the Management network, but for remote management for specific networks or
hosts, you should add a static route using the configure network static-routes command. Note that the
device manager management on data interfaces is not affected by this setting. If you use DHCP, the
system uses the gateway provided by DHCP and uses the data-interfaces as a fallback method if DHCP
doesn't provide a gateway.
• If your networking information has changed, you will need to reconnect—If you are connected with
SSH to the default IP address but you change the IP address at initial setup, you will be disconnected.
Reconnect with the new IP address and password. Console connections are not affected.
• Manage the device locally?—Enter yes to use the device manager or the CDO/device manager. A no
answer means you intend to use the management center to manage the device.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
Cisco Firepower 1100 Getting Started Guide
92
Threat Defense Deployment with the Device Manager
(Optional) Change Management Network Settings at the CLI

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English