Figure 46. Configurator GUI (RADIUS dialog)
3. Choose the RADIUS mode for the device by clicking the RADIUS
Mode drop-down and selecting one of the following options:
• Disabled: RADIUS functionality will be disabled.
• Enabled: RADIUS functionality will be enabled, and the
configuration options will be shown.
• Passthrough: If the device is a trackside-mounted Fluidity
device, this parameter can be used to simultaneously
activate RADIUS device authentication, and enable
RADIUS passthrough (communication between RADIUS-
authenticated vehicle-mounted devices and non-
authenticated trackside-mounted devices).
4. Enter the IP address or host name of the RADIUS server in the IP
address / hostname field.
5. By default, the RADIUS port number is 1812. Do not change the
port number unless there is a specific need to do so.
6. Enter the RADIUS access password in the Secret field. To read
the password as it is typed, check the show check-box.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 114 of 175
To Next Page
Loading...
