CAUTION
Do not over-tighten the nuts. Doing so could damage the
bracket components.
4.2. Installing the radio using tie-wraps
To install the radio transceiver on a wooden or metal utility pole using the
included tie-wraps, do the following steps:
1. Decide where on the utility pole the radio must be mounted,
taking access to the radio and line-of-sight into account.
2. Place the radio against the utility pole at the chosen mounting
point (below).
3. Route the two tie-wraps through the clamp holes of the radio’s
mounting lug (below).
Installing the radio
© 2021 Cisco and/or its affiliates. All rights reserved. Page 26 of 175
To Next Page
Loading...
