Need help?Do you have a question about the Cisco FLUIDMESH FM4200 Mobi and is the answer not in the manual?
General| Category | Transceiver |
|---|---|
| Model | FM4200 Mobi |
| Data Rate | Up to 300 Mbps |
| Power Supply | 9-36 VDC |
| Channel Bandwidth | 5, 10, 20, 40 MHz |
| Modulation | QAM, QPSK, BPSK |
| Operating Temperature | -40°C to +70°C |
| Power Consumption | 10W (typical) |
| Antenna Connector | 2 x N-Type |
Details the hazard of water ingress and required precautions for outdoor installations.
Explains RF exposure limits and minimum separation distances for safe operation.
Warns about hot unit surfaces during operation and the need for protective equipment.
Provides an overview of the Cisco FM4200 Mobi radio transceiver.
Step-by-step guide for mounting the radio transceiver using tie-wraps or hose clamps.
Instructions for mounting the radio transceiver unit onto a DIN rail.
Procedure for installing the unit using a quick-release sliding bracket.
Details the initial hardware installation procedures for Fluidmesh devices.
Explains how to connect the FM4200 Mobi to network and antennas.
Guides on how to access the Fluidmesh Partner Portal and register.
Steps to set up and enable two-factor authentication for enhanced security.
Describes tasks available for managing license codes via the Partner Portal.
Explains how to access and use the RACER™ web-based configuration portal.
Guides on finding technical documentation for Fluidmesh devices on the Partner Portal.
Lists the necessary software and hardware for configuring the FM4200 Mobi.
Details methods to access the FM4200 Mobi for configuration.
Instructions on how to switch between offline and online modes in the Configurator.
Covers general settings like operational mode, Prodigy version, and LAN parameters.
Covers modifying wireless settings like passphrase, country, frequency, and channel width.
Describes tools for monitoring link status and adjusting antenna alignment.
Explains how to use the Spectrum Graph for detecting RF interference.
Covers network control features including Ping softdog and FM-QUADRO.
Tools for diagnosing wireless network conditions, including Ping, Bandwidth, and Path MTU tests.
Covers advanced configuration options for radio parameters and network settings.
Covers management settings like view mode, changing credentials, and firmware upgrades.
Lists all available software plug-ins, their functions, and part numbers.
Standardized procedures for managing plug-ins across all Fluidmesh hardware devices.
Troubleshooting steps for issues accessing the login screen for device configuration.
Solutions for problems logging into the FM Racer web-based configuration interface.
Steps to take if the Administrator username or password for the Configurator interface is forgotten.
Checks to improve wireless link strength when it is poor or non-existent in Bridge mode.
Introduces the terms and prohibitions of the Fluidmesh Firmware license agreement.
An agreement between user and Fluidmesh regarding firmware terms.
Defines key terms used within the Fluidmesh End-User License Agreement.
Grants a non-exclusive, non-transferable license to use Fluidmesh Firmware.
Outlines permitted uses and restrictions for Fluidmesh Firmware and devices.
Addresses the acknowledgment and compliance with Open Source Software licenses.
Details conditions for license termination and consequences of unauthorized use.
Policy regarding user suggestions, comments, and other feedback.
Acknowledges Fluidmesh's right to collect and use device data for service improvement.
Disclaims warranties for Fluidmesh Firmware, devices, and documentation.
Limits Fluidmesh's liability for damages arising from firmware or device supply/use.
Excludes liability for emergency calls or services through Fluidmesh products.
States compliance requirements with U.S. export control laws and regulations.
General terms and conditions governing the license agreement.
To Next Page
