5.a.b.c
The triplet a.b.c uniquely identifies the individual physical hardware unit,
and cannot be changed.
The unit ID number is used to identify the physical hardware units within
the configurator interface that is used for configuration of the unit.
A simplified diagram demonstrating the relationship between a wired LAN,
and a linked mesh radio network containing a mesh end unit and mesh
point units, is shown in Figure 5 (page 22).
Figure 5. Fluidmesh Network Addressing
Operating the unit in Mesh Point mode or Mesh End mode
If the Cisco FM4200 Mobi radio transceiver unit is installed as part of a
mesh network architecture, it can be set to operate in either of two
operating modes:
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 22 of 177
To Next Page
Loading...
Need help?
General
