NOTE
When the General Mode window is opened for the first time,
the Local IP and Local Netmask LAN parameters will be
factory-set default values.
The information needed is self-explanatory. To enter a parameter, click the
field and type the parameter.
If needed, enter the local primary DNS address in the Dns 1 field, and
enter the local secondary DNS address in the Dns 2 field.
Save the LAN settings by clicking the Save button. Alternatively, clear the
settings by clicking the Reset button.
7.4.2. Wireless settings
Modifying the wireless settings
IMPORTANT
If the Cisco FM4200 Mobi was purchased in the USA or
Canada, the Country selection is set to the country of
purchase, and the Country: drop-down will be disabled.
The WIRELESS RADIO window contains controls to change the following
settings:
• The shared network passphrase.
• The national territory in which the wireless network is installed.
• The operational radio frequency and bandwidth settings.
To change the Wireless Settings, do the following steps:
1. Click the -wireless radio link under GENERAL SETTINGS in the
left-hand settings menu.
• The WIRELESS RADIO dialog will be shown (Figure 23
(page 64)).
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 63 of 177
To Next Page
Loading...
Need help?
General
