EasyManuals Logo

Cisco FLUIDMESH FM4200 Mobi User Manual

Cisco FLUIDMESH FM4200 Mobi
177 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
FLUIDITY FREQUENCY SCAN tab (Used where
mobile Fluidity units are configured with different
frequencies.)
SPANNING TREE tab (Allows you to build a logical
topology for Ethernet networks, including backup links
to provide fault tolerance if an active link fails.)
QOS tab (Contains controls for Quality of Service and
Class of Service settings.)
MPLS tab (Contains controls for adjustment of the unit's
multiprotocol label switching settings.)
FAST FAILOVER (TITAN) tab (Contains controls to
enable fast fail-over capability on networks where
backup units are installed.)
ARP tab (Contains controls for Address Resolution
Protocol settings used for discovering MAC addresses
that are associated with IP addresses.)
INTRA-CAR tab (Contains controls to create and
maintain a wireless backbone network throughout
physically large, compartmentalized vehicles.)
For a detailed description of the configuration options featured
in the FM Racer interface, refer to the Available configuration
parameters section of the Fluidmesh Networks FM Racer User
Manual.
7.1. Software and hardware prerequisites
To access the Configurator graphical user interface (GUI) and use the
Configurator to program the Cisco FM4200 Mobi, you need the following:
A desktop, laptop or tablet computer equipped with:
Any current web browser. For a list of compatible web
browsers, refer to the Supported web browsers table in
“Using the Fluidmesh Partner Portal” (page 43).
Any Microsoft Windows, Mac OS or Linux operating system.
An integrated Ethernet port.
A CAT5/6 Ethernet cable with an RJ45 connector at one end, and
an M12X connector at the other end.
7.2. Accessing the Cisco FM4200 Mobi for device
configuration
Before the unit can be made part of a wireless network, it must be
configured.
The on-board Configurator can be used to configure a Fluidmesh device
in either of two ways:
By connecting a control device directly to the Fluidmesh device
using an Ethernet cable (Local access)
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 50 of 177

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco FLUIDMESH FM4200 Mobi and is the answer not in the manual?

Cisco FLUIDMESH FM4200 Mobi Specifications

General IconGeneral
BrandCisco
ModelFLUIDMESH FM4200 Mobi
CategoryTransceiver
LanguageEnglish

Related product manuals