10. ELECTRICAL POWER REQUIREMENTS
The following table describes:
• The electrical power requirements for each Fluidmesh hardware
device type.
• Which Fluidmesh hardware devices are capable of receiving power
through an IEEE 802.3 Ethernet port (whether from a power-
supplying device like a compatible network switch, or from a power-
over-Ethernet (PoE) injector), or through a DC IN power supply
port, or both.
• The specific voltage-variation tolerances of each Fluidmesh radio
transceiver unit type.
Table 9. Individual power requirements (FM1000 Gateway Gateway
and FM10000 Gateway Gateway)
Required input
power
FM1000
Gateway
Gateway
FM10000
Gateway
Gateway
DC IN 12 Vdc (from mains
AC power adapter
producing a
minimum of 60W
(12V/5A)).
X
First-generation FM10000
Gateway Gateway: unit may be
equipped with single 250W
non-redundant AC power
supply unit (input power: 100
Vac to 240 Vac at 50 Hz to 60
Hz).
X
Table 10. Individual power requirements (FM Ponte kit to FM FM4200
Mobi)
FM
Ponte
kit
FM
FM1200
Volo
FM
FM1300
Otto
FM
FM3200
Base
FM
FM3200
Endo
FM
3200
+GPS
FM
3200
DEPOT
FM
FM4200
Mobi
PoE 24V
passive
PoE
X X
48V
passive
PoE
X X X X X
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 160 of 177
To Next Page
Loading...
Need help?
General
