Figure 9. Cisco FM1200 Volo (Hardware RESET button port)
3. Press the RESET button for one second, then release the button
immediately.
• The unit will reboot.
Resetting the unit to factory settings
CAUTION
Do not do a factory reset unless the unit needs to be
reconfigured using its factory configuration as a starting point.
A factory reset will reset the unit's IP address and administrator
password, and will disconnect the unit from the network.
The following methods are available to do a factory reset:
1. To do the reset using the offline Configurator interface, refer to
“Resetting the unit to factory defaults” (page 138).
2. To do the reset using FM Racer, refer to the Cisco Networks FM
Racer User Manual.
3. To do the reset by physically accessing the unit, follow the
procedure below.
To reset the radio to its factory default settings, do the steps that follow:
Power ON the unit.1.
Wait approximately 40 seconds for the unit to boot up.2.
3. When the unit has completed its boot sequence, press the
RESET button for 7 seconds.
• The LEDs will blink.
• The unit will be restored to factory default settings
(including its default IP address of 192.168.0.10 and
subnet mask of 255.255.255.0).
• The unit will reboot.
Hardware installation
© 2021 Cisco and/or its affiliates. All rights reserved. Page 35 of 175
To Next Page
Loading...
