Figure 67. Configurator interface (MANAGE PLUG-INS
dialog)
2. Click the red REMOVE link to the right of the correct plug-in
listing.
• The web browser will inform you that deactivating the plug-
in will reboot the unit, and ask for confirmation that you
want to deactivate.
Confirm the deactivation.3.
• The unit will reboot.
• The Deactivation code for the plug-in will be shown to the
right of the plug-in listing, in the Plug-in Deactivation
Codes section (see below).
(Plug-inDIALOGFigure 68. MANAGE PLUG-INS
Deactivation Codes section)
Make a note of the Deactivation code.4.
Log on to the Cisco Partner Portal.5.
Click the6. Plug-ins link.
• The Plug-ins web page will be shown (Figure 69 (page
149)).
Software Plug-Ins
© 2021 Cisco and/or its affiliates. All rights reserved. Page 148 of 175
To Next Page
Loading...
