Cisco IOS XE Intelligent Services - Page 106

Configuring ISG Access for IP Subscriber Sessions
How to Configure ISG for IP Subscriber Sessions
22
Verifying ISG IP Subscriber Sessions
Perform this task to verify IP subscriber session configuration and creation.
SUMMARY STEPS
1. enable
2. show subscriber session [detailed] [identifier identifier | uid session-id | username name]
3. show ip subscriber [dangling seconds | detail | ip ip-address | mac mac-address | vrf vrf-name
static list
listname [dangling seconds | detail | ip ip-address]]
4. exit
Step 5
action-number authorize [aaa list list-name]
[password password] [upon network-service-found
{continue | stop}] identifier
{authenticated-domain | authenticated-username
| auto-detect | circuit-id [plus remote-id] |
dnis | mac-address | nas-port | remote-id [plus
circuit-id] | source-ip-address | tunnel-name |
unauthenticated-domain |
unauthenticated-username}
Example:
Router(config-control-policymap-class-control)#
1 authorize identifier source-ip-address
(Optional) Initiates a request for authorization on the basis
of the specified identifier.
Step 6
action-number service-policy type service
[unapply] [aaa list list-name] {name
service-name | identifier {authenticated-domain
| authenticated-username | dnis | nas-port |
tunnel-name | unauthenticated-domain |
unauthenticated-username}}
Example:
Router(config-control-policymap-class-control)#
1 service-policy type service aaa list LISTA
name REDIRECT
(Optional) Activates an ISG service.
• Specifying an identifier instead of a service name will
activate a service that has the same name as the
specified identifier.
Step 7
action-number set-timer name-of-timer minutes
Example:
Router(config-control-policymap-class-control)#
1 set-timer TIMERA 5
(Optional) Starts a named policy timer.
• Expiration of the timer generates the event
timed-policy-expiry.
Command or Action Purpose