Troubleshooting ISG with Session Monitoring and Distributed Conditional Debugging
How to Enable ISG Session Monitoring and Distributed Conditional Debugging
3
ISG Distributed Conditional Debugging
This section contains the following concepts:
• Benefits of Enhanced Conditional Debugging for the ISG Platforms, page 3
• Cisco IOS XE Software Components Supported by Distributed Conditional Debugging, page 3
Benefits of Enhanced Conditional Debugging for the ISG Platforms
Because thousands of user sessions run on the ISG platforms, it is not practical to troubleshoot a problem
with a session by enabling the various component debug commands that are available and trace through
the messages for a single session or user. Instead, it is more practical to filter debugging messages for a
single session or call across the various Cisco IOS XE components that a session traverses. For this
reason, the conditional debugging previously offered in the Cisco IOS XE software has been enhanced
to facilitate debug filtering for ISG and is available as distributed conditional debugging.
Cisco IOS XE Software Components Supported by Distributed Conditional Debugging
The following components are supported for ISG distributed conditional debugging:
• Authentication, authorization, and accounting (AAA) and RADIUS
• Feature Manager
• Policy Manager
• PPP
• PPP over Ethernet (PPPoE)
• Session Manager
• Virtual Private Dialup Network (VPDN)
See Table 1 and Table 2 for specific commands that are supported for distributed conditional debugging.
How to Enable ISG Session Monitoring and Distributed
Conditional Debugging
This section contains the following tasks:
• Monitoring ISG Sessions and Flows, page 3
• Configuring Distributed Conditional Debugging, page 4
Monitoring ISG Sessions and Flows
Perform this task to monitor interface and CPU statistics. The show commands are not required and may
be entered in any order.
To Next Page
Loading...
Need help?
General