Cisco IOS XE Intelligent Services

Troubleshooting ISG with Session Monitoring and Distributed Conditional Debugging
How to Enable ISG Session Monitoring and Distributed Conditional Debugging
8
DETAILED STEPS
Displaying Debugging Conditions
To display the debugging conditions that have been set, perform the following task:
SUMMARY STEPS
1. enable
2. show debug condition
DETAILED STEPS
Troubleshooting Tips
The Cisco IOS software displays messages as you set the conditions for filtering the debugging.
When a condition is set, it is assigned a number, as follows:
Condition 1 set
If a condition has already been set, the following message is displayed:
% Condition already set
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
debug condition command
Example:
Router# debug condition username user@cisco.com
Enter one or more of the debug condition commands listed
in Table 1 to enable distributed conditional debugging.
Step 3
debug command
Example:
Router# debug subscriber aaa authorization fsm
Enter one or more of the supported debug commands from
Table 2.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
show debug condition
Example:
Router# show debug condition
Displays conditions that have been set for debugging.