Cisco IR809 Product Overview

• 4-pin 3.8 mm EURO power connector
• External Reset/Recovery Push Button
• WWAN Modem
• 1x internal Mini PCIe slot for Single multi-band 2G/3G/4G/LTE cellular modem
• Dual USIM Card slots (2 external SIM card slots). Provides Redundancy and multi-homing
capabilities over LTE and HSPA-based networks.
• WAN Ports
• 2x RJ45 10/100/1000 Gigabit Ethernet
• Serial Ports
• 1 x RJ45 RS232 DTE Port
• 1 x RJ45 RS232/RS485 DCE Port (SW-configurable)
• USB Ports
• 1x USB2.0 Type A External Host Port
• 1x USB2.0 Type Mini-B External Debug/Console Device Port
• Compliance
• Telcordia GR-3108 Class 2 deployment
• Class A EMC or better
• RoHS6
• IP30 compliant when vertical, IP40 compliant when mounted flat on a horizontal surface
Reset Button
The Reset button resets the router configuration to the default configuration set by the factory. To restore the
router configuration to the default configuration set by the factory, use a standard size #1 paper clip with wire
gauge 0.033 inch or smaller and simultaneously press the reset button while applying power to the router.
The reset button works in two different manners:
• With the reset button pressed for less than 10 seconds, the IR809 will load with saved start-up configuration
at that time.
• With the reset button pressed longer than 10 seconds, the NVRAM file system is erased and the IR809
boots up with Initial Configuration.
Supported Cisco Antennas and Cables
The Cisco IR809 ships without antennas. All antennas are options that can be ordered separately.
Product Overview
9
Product Overview
Supported Cisco Antennas and Cables

Cisco IR809 Specifications

General

Brand	Cisco
Model	IR809
Category	Network Router
Language	English