Cisco ISR User Manual

7-20
Cisco Wireless ISR and HWIC Access Point Configuration Guide
OL-6415-04
Chapter 7 Configuring RADIUS Servers
Configuring and Enabling RADIUS
Note By default, the access point sends reauthentication requests to the authentication server with the
service-type attribute set to authenticate-only. However, some Microsoft IAS servers do not support the
authenticate-only service-type attribute. Changing the service-type attribute to login-only ensures that
Microsoft IAS servers recognize reauthentication requests from the access point. Use the dot11 aaa
authentication attributes service-type login-only global configuration command to set the
service-type attribute in reauthentication requests to login-only.
Ta b l e 7-6 Attributes Sent in Accounting-Request (stop) Packets
Attribute ID Description
1 User-Name
4 NAS-IP-Address
5 NAS-Port
6 Service-Type
25 Class
41 Acct-Delay-Time
42 Acct-Input-Octets
43 Acct-Output-Octets
44 Acct-Session-Id
46 Acct-Session-Time
47 Acct-Input-Packets
48 Acct-Output-Packets
49 Acct-Terminate-Cause
61 NAS-Port-Type
VSA (attribute 26) SSID
VSA (attribute 26) NAS-Location
VSA (attribute 26) Disc-Cause-Ext
VSA (attribute 26) VLAN-ID
VSA (attribute 26) Connect-Progress
VSA (attribute 26) Cisco-NAS-Port
VSA (attribute 26) Interface
VSA (attribute 26) Auth-Algo-Type

Cisco ISR Specifications

General

Brand	Cisco
Model	ISR
Category	Wireless Access Point
Language	English