Cisco NCS 5500 Series Command Reference

hw-module profile qos ingress-model peering
To enable the peering QoS profile feature, use the hw-module profile qos ingress-model peering command
in the XR Config mode. To disable this feature, use the no form of this command.
hw-module profile qos ingress-model peering [locationnode-id]
Syntax Description
Indicates the designated node. The node-id argument is entered in the rack/slot/module
notation.
location node-id
Command Default
The peering QoS profile feature is disabled by default, unless enabled by this command.
Command Modes
XR Config mode
Command History
ModificationRelease
This command was introduced.Release
6.2.1
Usage Guidelines
The router must be reloaded for the hw-module command to be functional.
Task ID
OperationTask
ID
read,
write
qos
The following example shows how to enable the peering QoS profile feature.
RP/0/RP0/CPU0:router#config
RP/0/RP0/CPU0:router(config)#hw-module profile qos ingress-model peering
RP/0/RP0/CPU0:router(config)#commit
RP/0/RP0/CPU0:router# reload
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
8
QoS Classification Commands
hw-module profile qos ingress-model peering

Cisco NCS 5500 Series Specifications

General

Series	NCS 5500
Category	Network Router
Operating System	Cisco IOS XR
Product Type	Modular Router
Form Factor	Rack-mountable
Purpose	High-performance routing for service providers and large enterprises
Interface Types	Ethernet
Redundancy	Redundant power supplies and fan trays
Port Density	Varies by model; high-density configurations available
Routing Protocols	BGP, OSPF, IS-IS, MPLS
Power Supply Options	AC and DC power supplies available
Management	CLI, SNMP, NETCONF