Cisco NCS 5500 Series Command Reference

hw-module profile stats qos-enhanced
To enable the four counter mode in the system, use the hw-module profile stats qos-enhancedcommand in
XR Config mode. To disable this mode, use the no form of the command. In the four counter mode, statistics
for conform, violate, and exceed packets are collected in the hardware and displayed using the show policy-map
command.
hw-module profile stats qos-enhanced
Syntax Description
This command has no keywords or arguments.
Command Default
The qos-enhanced mode is disabled by default, and therefore only the conform and violate statistics are
available in the two counter mode.
Command Modes
XR Config mode
Command History
ModificationRelease
This command was introduced.Release
6.2.1
Usage Guidelines
The router must be reloaded for the hw-module command to be functional.
Task ID
OperationTask
ID
read,
write
qos
The following example shows how to enable the four counter mode on the router.
RP/0/RP0/CPU0:router#config
RP/0/RP0/CPU0:router(config)#hw-module profile stats qos-enhanced
RP/0/RP0/CPU0:router(config)#commit
RP/0/RP0/CPU0:router# reload
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
10
QoS Classification Commands
hw-module profile stats qos-enhanced

Cisco NCS 5500 Series Specifications

General

Series	NCS 5500
Category	Network Router
Operating System	Cisco IOS XR
Product Type	Modular Router
Form Factor	Rack-mountable
Purpose	High-performance routing for service providers and large enterprises
Interface Types	Ethernet
Redundancy	Redundant power supplies and fan trays
Port Density	Varies by model; high-density configurations available
Routing Protocols	BGP, OSPF, IS-IS, MPLS
Power Supply Options	AC and DC power supplies available
Management	CLI, SNMP, NETCONF