Cisco Nexus 1000V - Page 128

9-16
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 9 Ports
Port Troubleshooting Commands
Model: --
Type: --
Speed: 10,100,1000,auto
Duplex: half/full/auto
Trunk encap. type: 802.1Q
Channel: no
Broadcast suppression: none
Flowcontrol: rx-(none),tx-(none)
Rate mode: none
QOS scheduling: rx-(none),tx-(none)
CoS rewrite: yes
ToS rewrite: yes
SPAN: yes
UDLD: yes
Link Debounce: no
Link Debounce Time: no
MDIX: no
Port Group Members: none
switch#
Example 9-14 show interface virtual port-mapping Command
switch# show interface virtual port-mapping
-------------------------------------------------------------------------------
Port Hypervisor Port Binding Type Status Reason
-------------------------------------------------------------------------------
Veth1 DVPort5747 static up none
Veth2 DVPort3361 static up none
switch#
Example 9-15 module vem execute vemcmd show portsec status Command
cyp1-switch# module vem 3 execute vemcmd show portsec status
LTL if_index Max Aging Aging DSM Sticky VM
Secure Time Type Bit Enabled Name
Addresses
56 1c0000a0 5 0 Absolute Clr No Ostinato-Upgrade-VM1.eth1
Example 9-16 show port-security Command
switch# show port-security
Total Secured Mac Addresses in System (excluding one mac per port) : 0
Max Addresses limit in System (excluding one mac per port) : 8192
----------------------------------------------------------------------------
Secure Port MaxSecureAddr CurrentAddr SecurityViolation Security Action
(Count) (Count) (Count)
----------------------------------------------------------------------------
Vethernet1 1 0 0 Shutdown
==========================================================================
Example 9-17 show port-security address interface vethernet Command
switch# show port-security address interface vethernet 11
Secure Mac Address Table
----------------------------------------------------------------------
Vlan/Vxlan Mac Address Type Ports Configured Age
(mins)