Cisco Nexus 1000V - Page 184

16-6
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 16 ACLs
Troubleshooting ACL Logging
BEFORE YOU BEGIN
• Log in to the VSM and VEM CLI.
PROCEDURE
Troubleshooting a Maximum Flow Limit Value That is Too Low
If the number of flows does not reach 5000 for either permit of deny flows, you can increase the
maximum flows.
BEFORE YOU BEGIN
• Log in to the VSM and VEM CLI.
PROCEDURE
Command Description
Step 1
show running-config aclmg
Example
switch# show running-config aclmg
switch #
Verifies that the log keyword is enabled.
Step 2
show logging ip access-list status
Example:
switch# show logging ip access-list
status
switch #
Verifies that ACL logging is configured properly.
Step 3
vemcmd show acllog config
Example:
switch# vemcmd show acllog config
switch #
Verifies ACL logging on the VEM.
Command Description
Step 1
show logging ip access-list status
Example:
switch# show logging ip access-list status
switch #
Verifies that ACL logging is configured properly.