Cisco Nexus 1000V - Page 242

24-6
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 24 Network Segmentation Manager
Problems with Network Segmentation Manager
The network creation triggered from
vCloud Director fails. A system
message similar to the following is
logged in vCloud Director:
Failed to set segment ID
vCloud Director is unable to set the
segment ID associated with the
network.
Verify that the segment ID is not already in use
by another bridge domain.
show bridge-domain
Check the error message on the system log to
retrieve the segment ID.
The network creation triggered from
vCloud Director fails. A system
message similar to the following is
logged in vCloud Director:
Failed to set group IP
vCloud Director is unable to set the
group IP associated with the
network.
Verify that the group IP is a valid multicast IP
address by checking the system logs for invalid
IP address error message reported by NSM. See
the Cisco NX-OS System Messages Reference for
more information.
The network creation triggered from
vCloud Director fails. A system
message similar to the following is
logged in vCloud Director:
Failed to set port-profile
description
vCloud Director is unable to set the
description for the port profile
associated with the network.
Check system logs for a port profile description
failure message reported by NSM. See the Cisco
NX-OS System Messages Reference for more
information.
The network deletion triggered from
vCloud Director fails. A system
message similar to the following is
logged in vCloud Director:
Failed to delete interface
using the port-profile
vCloud Director is unable to delete
the interfaces inheriting the port
profile.
1. Manually delete the interfaces.
2. In vCenter Server, ensure that the VMs
associated with the vApp are powered down.
3. In the VSM enter the no interface
vethernet vethernet number command.
The network deletion triggered from
vCloud Director fails. A system
message similar to the following is
logged in vCloud Director:
Failed to delete the
port-profile
vCloud Director is unable to delete
the port profile associated with the
network.
1. Manually delete the port profile.
2. Check system logs for a port profile deletion
failure message reported by NSM. See the
Cisco NX-OS System Messages Reference
for more information.
An vEthernet interface is
administratively down. The interface
will be in the NoPortProfile state.
The vEthernet interface is in a
quarantine state.
1. Verify the interface is quarantined.
show port-profile sync-status
2. Bring the interface out of quarantine.
no shutdown
The interface comes back online.
3. Verify if the interface is online.
show interface vethernet
Symptom Possible Causes Verification and Solution