5-4
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 5 Upgrades
Problems with the In-Service Software Upgrade
Error message:
Another install procedure
may be in progress.
(0x401E0007)
Another upgrade session is in
progress from a VSM console
or SSH/Telnet.
Do one of the following:
• Continue the first upgrade session in progress.
• Stop the upgrade and restart one session only using the
instructions in the Cisco Nexus 1000V Installation and
Upgrade Guide.
The install command fails
with following error
message:
-- FAIL. Return code
0x4093001E (Standby
failed to come online)
Install has failed. Return
code 0x4093001E (Standby
failed to come online)
The standby VSM fails to
boot with the new image.
Do one of the following:
• Restart the software upgrade using the instructions in
the Cisco Nexus 1000V Installation and Upgrade Guide.
• Postpone the upgrade and reset the boot variables to the
original filenames.
boot kickstart filename [sup-1] [sup-2]
The install command fails
with following error
message:
Install has failed.
Return code 0x4093001F
(Standby installer failed
to take over the
installation).
Please identify the cause
of the failure, and try
“install all” again”
The standby VSM takes more
than 10 minutes to come up
and form a stable HA pair
with the active VSM.
1. Reset the boot variables to the original filenames.
boot kickstart filename [sup-1] [sup-2]
2. If the standby is still running the new software version,
reload it.
reload
The standby synchronizes with the active, so that both
are running the original software version.
The install command fails
with following error
message:
Module 2: Waiting for
module online.
-- SUCCESS
-- Install has failed.
Return code 0x40930000
(Current operation failed
to complete within
specified time)
A failure at the standby VSM
caused it to reload again after
the Continuing with
installation, please wait
message and before the
switchover.
1. Inspect the logs.
show logging
2. Look for standby reloads caused by process failures.
show cores
If a process crash is observed, collect details of the
upgrade and open a support case.
show system internal log install details
3. Restart the software upgrade using the instructions in
the Cisco Nexus 1000V Installation and Upgrade Guide.
The pre-upgrade check
failed:
Return code 0x40930062
(free space in the filesystem
is below threshold).
1.
Table 5-1 (continued)Problems with the ISSU
Symptom Possible Causes Solution
To Next Page
Loading...
